Product Center

Closed sampler series

The rocker plug type closed sampler

|Product introduction

Our KMC series is to follow the SH0233-92 sampler "liquefied petroleum gas sampling method", manufacturing and design, UOP technology. Suitable for oil and chemical equipment in various media, especially toxic, harmful, flammable, explosive and other hazards in the medium and low pressure gas liquid media without leakage sampling. The sample with strong authenticity, high accuracy, no residual liquid and gas emission. Effectively prevent toxic and harmful media damage to the operator. At the same time will not pollute the environment, to avoid the flammable and explosive media in the sampling may cause the risk of accidents. Meet the requirements of the state for environmental protection, fire protection, explosion protection, etc..
KMC series sampler for a total of three categories, respectively, gas closed sampler, the confined liquid sampler, a rocker plug type closed sampler.
Rocker faucet type sampling system is mainly used for liquid or powder medium samples were collected, this sampler shake into the top of the rocker against a sample storing, shake out into new, with nitrogen of sampling valve export purge to remove residual in the valve and needle samples, applicable to collecting barrel groove and the process pipelines in representative samples.

|product mix

|Product technical parameters

The system uses plug rocker, mainly used for liquid or powder medium, shake into the top of the rocker against a sample storing, shake out into new, with nitrogen of sampling valve export purge to remove residual in the valve and needle samples, applicable to collecting barrel groove and the process pipelines in representative samples, samples were removed from the pipeline process, in the pipeline pressure pressed into bottle.
Bottle cap and gasket is attached to the bottle and sampling time to keep the bottle stuck inside the shield, bottle cap gasket will needle punctured, the rotary plug valve handle inflow into the sample bottle. Air and steam in the bottle will be discharged by the air vent. After reaching the sampling volume closed plug valve, then the bottle out of the inner shroud. At this time cap gasket will automatically shut, so as to achieve the sealing effect of sampling.
[major component]:
1, with a plug type sampling valve
2, with purge pipeline
3, no residual style blowing pipeline
[applicable conditions and characteristics]:
1, online direct sampling
2, zero residual representative sampling
3, high viscosity medium
4, needle without blocking
5, low pressure condition

|Installation and maintenance

[safety precautions]
1, sampling bottle collection media should be the volume of 70-85%.
2, has been filled with the sampling of the sample bottle, must be far away from the fire source, to prohibit close to high temperature and exposure in the sun.
3, use should be carefully examined before sampler of the pipe joints is connected closely, such as loose, should be timely maintenance before use.
4, sampling bottles and joints between the seal should be regularly checked, if any damage should be replaced in a timely manner.

|Order notice


 

About Kaifan

To achieve success with quality products;
The pride of the company rests in its quality;
In the pursuit of excellence we discard the mediocre. No expenses spared, with rigorous development;
With standardized quality control and systematic quality assurance, this is Kaifan’s promise;
The world’s end is no obstacle to Kaifan;
Kaifan, in cooperation with its local partners, manufactures products of impeccable quality...

Customer case

Related links