Product Center

Precision filter series

Nature Gas Filter separator

|Product introduction

Filtration separator can be used to remove solid and liquid impurities from gas, applying to fuel gas and other gas. Our product is mainly applied to remove solid and liquid particle, whatever the size of particles. Filtration separator especially applies to remove extremely mini dust and smog.

|product mix

|Product technical parameters

Working Principle:
First, nature gas enters into the gas distribution chamber. Gas strikes on the support tube of the cartridge, large particles being separated and sinking to the bottom of the vessel because of gravity. Then gas goes through coalescing filter cartridge, and solid particles are held back by filtration media, while liquid particles coalescent on the internal face of cartridge. When the droplets reach a certain size, they will drop off from the inner face due to the impact of a gas stream and enter into the internal flow path, flowing out of the distribution chamber. Meanwhile, larger droplets are separated by gravity. Moreover, separation parts can collect droplets effectively, to avoid droplets being carried, improving separating effect. Finally, clean gas flows out of filtration separator. With gas throughput increasing, particles deposited on the cartridge will increase the differential pressure. When differential pressure reaches the set point (which can be read from the gauge), cartridge has been seriously blocked, which should be replaced in time. Initial differential pressure should be no more than 20KPa. Replacing differential pressure should be no more than 1000KPa.
 
Equipment Structure:
Filtration separator consists of cartridge, crust, quick opening closure and inner and outer parts with horizontal structure and quick opening closure structure. Basic structure is as the picture shows:
 
Technical Parameter:
• Working pressure: 1.6~25.0Mpa
• Working temperature: -40~300℃
• Accuracy of filtering separation: 99.98%
• Maximum flow: 1000000Nm3/h
 
Options:
Quick opening closure (Hoop, clamp)
Safety valve, sewage valve, importers ball
Pressure difference switch, pressure difference transmitter, Level meter
Level switch, prying installation

|Installation and maintenance

1, the core component of the precision filter is the filter of the filter, the filter is easy to damage the parts, need special protection.
2, the precision filter for a long time to work, will cut a certain amount of impurities, this will work when the rate decreased, so it must be cleaned regularly, but also to clean the filter.
3, in the cleaning process to pay special attention to the cleaning of the filter filter, do not deform or damage, otherwise it will lead to a reduction of filter precision, not to the production requirements.
4, if the filter is found to be deformed or damaged, must be replaced immediately.
5, some precision filter, can not be used repeatedly, such as bag filter, polypropylene filter, etc..

|Order notice

Order shall be determined by the following parameters: diameter; work pressure; (3) material; (4) flange standard; dielectric; the operating pressure; to give you provide suitable products.

About Kaifan

To achieve success with quality products;
The pride of the company rests in its quality;
In the pursuit of excellence we discard the mediocre. No expenses spared, with rigorous development;
With standardized quality control and systematic quality assurance, this is Kaifan’s promise;
The world’s end is no obstacle to Kaifan;
Kaifan, in cooperation with its local partners, manufactures products of impeccable quality...

Customer case

Related links